What is power antenna wire in car stereo?

Do I need to connect the power antenna wire?

Yes, these two wires should be connected together. This is what allows the radio to retract the antenna when it isn’t being used.

What wire does the power antenna wire connect to?

One thing to note, most head unit wiring harnesses also have a solid blue wire. This wire is typically for power antenna or factory amplifier turn on, do not get this wire confused with the remote turn on wire with the blue/white stripe.

Do you need power antenna?

So an amplified antenna is always going to need power. Most amplified antennas won’t work without a power source because the amplifier circuits are built right into the antenna so the signal just gets stopped if there’s no power to the amplifier.

What do I connect the blue power antenna wire to?

Connect both blue (to power antenna) and blue/white (to remote amp terminal) wires to the blue/white (remote wire from Head Unit). Now, when you power on the radio, the antenna will also rise.

INTERESTING:  Your question: What happens if you put transmission fluid in your brake fluid?

Is power antenna the same as remote?

Almost every aftermarket head unit has a remote turn on wire. Some manufacturers call it a power antenna wire. But regardless of the label all it does is output a positive 12 volts when the head unit is turned on. It should be noted that some head units have both a remote turn on wire and a power antenna wire.

What color is power antenna wire?

Ground wires are black, antenna wires are blue, and amplifier wires are blue with a white stripe.

What color wires go together in a car stereo?

For example, while the grey wire is the (+) for the right front speaker, the grey wire with black stripes is the (-) for the same speaker. Likewise, the white wires connect to the left front speaker; purple wires indicate the right rear speaker, and the green wires are for the left rear speaker.

What is the pink wire on car stereo?

Pioneer – The pink wire works for Car Speed Signal Input in a pioneer stereo system. So, connecting it will allow the stereo to access the speed sensor data of your car.

How does a power antenna work?

A power antenna has a reversible reel motor in its base, and the antenna mast has a nylon cord attached to the bottom side of the antenna. This cord is wrapped around the reel and, as the reel reverses from one direction to another, it causes the antenna mast to either go up or extract back into its housing.

How much power does an antenna need?

For the old test standard, many test houses were sold antenna/amplifier combinations that included a 30-watt amplifier and a log periodic antenna. A 30-watt amplifier will produce a guaranteed minimum linear power of about 20 watts. At 80 MHz, log periodic antennas require about 5 watts to produce 10 V/m at 1 meter.

INTERESTING:  Who has the best transmission?

Where does blue wire go on antenna adapter?

Installation Note: A blue wire is attached to the antenna adapter. When installing the adapter, the blue wire should be connected to the antenna turn-on lead of your new head unit.