Quick Answer: Can you clear codes at AutoZone?

Does AutoZone clear engine codes?

Option A: Go to Autozone

The answer is yes, but… there are a couple things to remember: What is this? Local auto parts stores will typically offer to read your codes for free, but not all locations will clear the light due to liability issues.

Can AutoZone erase check engine light?

Did you know that you can get your check engine light scanned for free? Any of the major parts stores in the country, such as: Napa, Advance Auto, Autozone and O’Reilly’s, will scan your vehicle, and tell you the P codes for no charge at all.

Does disconnecting battery clear codes?

Leaving the battery disconnected for about 15 minutes will ensure the vehicle systems will completely reset when you reconnect the battery. Secure the negative cable back to the terminal and cover it with the cap (if applicable). Disconnecting the battery will clear the error codes and reset the check engine light.

How do I clear my check engine light without a scanner?

To reset a check engine light without a scanner, disconnect the negative battery cable and wait a few moments. This will reset the diagnostic system in your vehicle, and if the underlying issue has indeed been resolved, the light should go off immediately.

INTERESTING:  How can you stop your transmission from slipping?

Is it OK to clear engine codes?

Clearing the check engine light can cause your car to fail smog. If you’re trying to pass a smog test, clearing the check engine light isn’t a fix. Yes, a car will automatically fail a smog check if the check engine light is on. However, clearing codes won’t make it pass.

Does O’Reilly clear codes?

You can narrow down your list of potential problems by reading codes set off by your car at most major-chain parts stores, such as AutoZone or O’Reilly’s. In addition, parts stores can clear the codes after reading them, which makes it impossible for your car to find any problems.

How far do you have to drive to reset the check engine light?

The reset can happen automatically after around 10 to 20 cycles. A cycle is a phase where you turn on the car and turn it off again. For other vehicles, you’ll have to drive around 50 to 100 miles before it resets. As you can imagine, you can drive the car with the check engine light on for long periods.